![]() ![]() Notify the SCSI midlayer of any changes detected. ![]() Tape drives, or newly configured or deleted logical drives, etc.) and Writing to this attribute will cause theĭriver to scan for new, changed, or removed devices (e.g., hot-plugged HPSA-specific host attribute files in /sys /sys/class/scsi_host/host*/rescan This is a write-only attribute. ![]() Generic driver ( sg(4)), with device nodes named /dev/sd*, Via the SCSI tape driver ( st(4)), and the RAID controller via the SCSI Logical drives are accessed via the SCSI disk driver ( sd(4)), tape drives (either hpacuxe(8) or hpacucli(8)) or the Offline ROM-basedĬonfiguration Utility (ORCA) run from the Smart Array's option ROM at boot To configure HP Smart Array controllers, use the HP Array Configuration Utility Since Linux 4.14, the following Smart Array boards are also The hpsa driver supports the following Smart Array boards: Supported with hpsa, and cciss(4) should still be used for These older boards have not been tested and are not Hpsa to drive older controllers that would normally be handled by theĬciss(4) driver. That predates the RAID controller, though it may also be used to enable Typically this is used to allow installation of operating systems from media This allows newer hardware to work with older drivers. Options hpsa_allow_any=1: This option allows the driver to attempt to operate onĪny HP Smart Array hardware RAID controller, even if it is not explicitly SYNOPSIS modprobe hpsa DESCRIPTION hpsa is a SCSI driver for HP Smart Array RAID controllers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |